Monday, July 13, 2009

Making sections through the site toposurface always resulted in very "thick" drawings:

Putting these on drawings and adjusting the crop-box always resulted in uneven drawings. Not really satisfactory.

Well then, at our on-site training today we learned that you can adjust de depth to which the surface pattern is drawn:

Go to Ribbon:Massing & Site:Model Site and press the little arrow:

You will the get the following dialog where you can adjust the "Elevation of poche base" value to less than the 5m that are standard.
This will greatly reduce the "thickness" of your sections and make them all even on you drawings.


Post a Comment